Heavy Duty Electric Motor Cast Iron 75HP 1800RPM 575V 365T

$5,700.70
(No reviews yet) Write a Review
SKU:
EM75-18-575-365T
Short Description:
Three Phase T-Frame Motor
Brand:
Electric Motors
Condition:
New
HP:
75
Phase:
Three
RPM:
1800
Frame:
365T
Enclosure:
TEFC

General Purpose Heavy Duty Cast Iron Electric Motor used for > Service factor: 1.15 @ 60 Hz; 1.0 @ 50 Hz; Suitable for 575V @ 1.0; NEMA Design B Performance/ High starting torgue; F1/F2 reversible; Dual-drilled feet for mounting flexibility; Lifting provision. Class F insulation system; Class B rise at full load; Class H vacuum pressure impregnation (VPI) resin for all windings; Corrosion-resistant epoxy paint and stainless steel nameplate and zinc plated hardware; IP55 protection; Condensation drain with plugs. Sealed bearings through 215T frame, regreasable open bearings on 254T frame and above; insulated bearings on ODE available on 444T frame and above.

 

 

Product Features:

  • Meets or exceeds NEMA Premium® Efficiency Requirements defined by NEMA MG-1, Table 12-12
  • Class I, Div II Groups ABCD, T2B
  • Suitable for wye-delta start on 213T frame and above
  • Dual voltage ratings suitable for part wind start on lower voltage
  • Single voltage ratings suitable for part wind start at 460V are noted
  • 1.15 Service Factor @ 60 hertz; 1.0 Service Factor @ 50 hertz
  • Suitable for 575V @ 1.0 Service Factor
  • Inverter Duty (20:1 variable torque; 10:1 constant torque)
  • Vacuum Pressure Impregnation for all windings
  • Sealed bearings thru 215T frame
  • Greasable bearings 254T frame and above
  • Mechanical “V” Seal on drive end
  • Class F insulation system, class B rise at full load
  • 40° C ambient continuous duty
  • Corrosion resistant paint
  • Stainless steel nameplate and zinc plated hardware
  • F1/F2 reversible
  • Feet are dual drilled on most frames for mounting flexibility
  • Cast iron frame construction including the conduit box
  • C-Flange and D-Flange field conversion kits available
  • Lifting provisions on 143T frame and above
  • Condensation drains with plastic plugs
  • IP55 Protection – Terminal box is sealed for IP66 protection
  • CSA + C + US Certification
  • ISO 9001 Certification

Product Details:

Weight 941 lbs
HP

75

RPM

1800

Frame

365T

Mult. Sym.

M16

Volts

575

Frame Type

NEPE

Enclosure

TEFC

F.L. Eff.

95.4

"C" Dim.

33.5

Notes

1,2,3,5

F.L. Amps

69.4

This motor is a direct replacement for these motors:

Baldor M4316T, Leeson G150031